24 Oct Battery Charging – A Multitude Of Hazards
Battery Charging – A Multitude Of Hazards
Servicing, charging, or jump-starting lead-acid batteries can expose workers to several serious hazards, including explosive hydrogen gas, corrosive electrolyte, electrical shorts and burns, flying battery fragments, and lifting injuries. These hazards can be controlled by using proper PPE, adequate ventilation, correct equipment, and safe work practices.
Eye and Face Protection
Lead-acid batteries contain corrosive electrolyte that can cause severe skin and eye burns. Batteries may also rupture or explode, releasing electrolyte and fragments.
- Wear chemical splash goggles when servicing or charging batteries.
- Use a face shield over goggles when there is a significant splash or explosion hazard.
- Keep your face away from battery openings and vent caps.
- Avoid touching your eyes or face after handling batteries.
- Know the location of emergency eyewash and flushing facilities.
- If electrolyte contacts the eyes or skin, immediately flush the affected area with plenty of water and follow established first-aid procedures.
Fire and Explosion Prevention
Lead-acid batteries can generate flammable hydrogen gas, particularly during charging. A spark, flame, cigarette, or other ignition source can ignite accumulated hydrogen and cause an explosion.
- Charge batteries only in designated, adequately ventilated areas.
- Keep flames, sparks, smoking materials, and other ignition sources away.
- Turn off the charger before connecting or disconnecting charging leads whenever required by the manufacturer’s instructions.
- Keep metal tools and other conductive objects away from battery terminals.
- Never place tools or metal objects on top of a battery.
- Inspect batteries, chargers, cables, and connectors before use.
- Do not charge a frozen, damaged, leaking, or visibly defective battery.
Safe Jump-Starting
Always follow the vehicle and battery manufacturer’s instructions, because jump-starting procedures may vary between vehicles.
For conventional negative-ground vehicles, the general procedure is:
- Turn off vehicle accessories and electrical loads.
- Verify that both electrical systems use the same voltage.
- Connect the positive (+) cable to the positive terminal of the discharged battery.
- Connect the other positive (+) end to the positive terminal of the good battery.
- Connect the negative (–) cable to the negative terminal of the good battery.
- Make the final negative connection to the designated grounding point or a clean, unpainted metal part of the disabled vehicle, away from the battery, as directed by the manufacturer.
- After starting, disconnect the cables in the manufacturer’s recommended sequence, generally the reverse of connection.
Never allow jumper cable clamps to touch each other or contact unintended metal surfaces while connected.
Electrical Hazards
A battery can produce enough current to cause severe burns, arcing, or equipment damage if terminals are accidentally shorted.
Remove conductive jewelry such as rings, watches, and bracelets before working around batteries. Use insulated tools when appropriate and protect battery terminals from accidental contact.
Never intentionally short across battery terminals to test a battery.
Battery Handling and Lifting
Vehicle and industrial batteries can be heavy and awkward to handle.
- Use a battery carrier, lifting device, or other mechanical assistance when practical.
- Get assistance with batteries that are too heavy or awkward to handle safely.
- Keep the battery upright during handling.
- Keep the load close to your body and avoid twisting while lifting or carrying.
- Use carts or other material-handling equipment for transporting heavy batteries.
Remember
A battery may look harmless, but it combines chemical, electrical, fire, explosion, and material-handling hazards. Wear proper PPE, eliminate ignition sources, provide adequate ventilation, follow manufacturer instructions, and never take shortcuts when charging, servicing, or jump-starting batteries.